Allen Bradley PLC programming in Micro Logix Software
This is a comprehensive course for learning the basic level programing of Allen Bradley PLC in Micro Logix software. You will learn the logic designing of Micro Logix from scratch in a short period. No hardware equipment will be required to follow the course you will just have to install Micro Logix software on you PC and you can do it. Fundamental programming of Micro Logix will be covered step by step including the video lectures, assignments.
What you’ll learn
- To understand how a Programmable Logic Controller (PLC) works.
- Pass a technical PLC interview.
- Understand how to program a PLC.
- Learn Ladder Logic Programming.
- Industrial Automation.
- Micro Logix programming interface.
Course Content
- Introduction to Course –> 1 lecture • 2min.
- Introduction of Relay Logic –> 1 lecture • 4min.
- Introduction to Allen Bradley Micro Logix PLC –> 1 lecture • 9min.
- Basics of RS Logix 500 Software and Communication with PLC or Simulator –> 2 lectures • 14min.
- Basic Parameters –> 1 lecture • 7min.
- General Internal Memories –> 1 lecture • 3min.
- Latching –> 2 lectures • 6min.
- Timers –> 2 lectures • 19min.
- Counters –> 1 lecture • 11min.
- Arithmetic Operations and MOVE Command –> 1 lecture • 11min.
- Comparator Operations –> 1 lecture • 7min.
- Designing of Complex Systems using Ladder Logic –> 0 lectures • 0min.
Requirements
This is a comprehensive course for learning the basic level programing of Allen Bradley PLC in Micro Logix software. You will learn the logic designing of Micro Logix from scratch in a short period. No hardware equipment will be required to follow the course you will just have to install Micro Logix software on you PC and you can do it. Fundamental programming of Micro Logix will be covered step by step including the video lectures, assignments.
Couse Outline:
1- Introduction of Relay Logic
2- Introduction to Allen Bradley Micro Logix
• PLC Block Diagram
• PLC Inputs and Outputs
• Working Principle of PLC
• PLC Communication Protocols
• PLC Wiring
• Sink/Source
• NPN & PNP Sensors
3- Basics of Micro Logix 500 Software and Communication with PLC
• PLC Specification
• Software Interface
• How to Create Tags
• Making First Program on Simulator
• Setting up Communication
• How to Monitor the Program Online
• How to Load Program in Simulator
• How to Build Ethernet Connection with PLC and Load Program
4- Basic Parameters
• Normally Open Contact
• Normally Close Contact
• Output Coil
• Series-AND Logic
• Parallel-OR Logic
• Parallel-NAND Logic
• Series-NOR Logic
• Assignment_1
5- General Internal Memories
6- Latching
• Latching with Output
• Latching using Latch and Unlatch Command
7- Timers
• On Delay Timer
• Enable of Timer
• Specifying the Duration of Time
• Resetting a Timer
• Off-Delay Timer
• Retentive On-Delay Timer
• Assignment_2
8- Counters
• Up Counter
• Resetting a Counter
• Down Counter
• Up-Down-Counters
• Assignment_3
9- Arithmetic Operations and MOVE Command
• Addition
• Subtraction
• Multiplication
• Division
• Moving Operands
• Moving Constants
10- Comparator operations
• Equal (=)
• Less Than (>)
• Greater Than (<)
• Designing of Complex Systems using Ladder Logic
11-Designing of Complex System Using Ladder Logic
• Assignment (Chemical Processing Unit)